Technical Features; Servicing And Maintenance Instructions - STAYER WELDING PROGRESS 1700L Manual De Instrucciones

In turn, the alternating mode (AC) mode may be pulsed to provide
special features, such as facilitating drop-per-drop filling, caloric
control or improved surface finishing. This mode produces pure
square wave without any passing time and excellent cleanliness.
DIAGNOSIS TIG AC/AC:
Error code in TIG AC/DC
804 Thermal Protection
805 Broken torch, switch short
806 Water loss

5.- SERVICING AND MAINTENANCE INSTRUCTIONS

5.1.- Cleaning, maintenance, lubrication, sharpening.
For cleaning, always disconnect the equipment and wait at
least 10 minutes for the sake of safety regarding the discharge
of the power capacitors. Clean the housing using a slightly wet
cloth. Depending on the pollution of the work environment or at
least each 1000 hours, clean the inside with dry pressurized air,
removing the upper housing and removing dust, metal pollutants
and fluff, paying special attention to the dissipators and the fan.
The equipment does not need special maintenance by the user,
whereby careful use within the environmental limits is the best
guarantee for long years of safe service. It is recommended to
send the equipment to the technical services after each 3000
work hours or every 3 years for verification and recalibration.
5.2.- Repair services with directions.
STAYER IBERICA
Área empresarial Andalucía – Sector I
Calle Sierra de Cazorla, 7
Postal Code: 28320
Pinto (Madrid) SPAIN
List of user-replaceable parts
Due to the complexity and potential hazard, qualified intervention
is required, except for minor repairs as inspection of connections
and replacement of the standard power supply plug and revision
of the welding cables, which thus are not considered user-
replaceable parts.
ENGLISH
37
6.- Regulations

6.1.- Technical features

= tension input
= current input
= current output
%
= work cycle
ON
OFF EN60974
-
= mass
= dimensions
-
= generator power
We declare under our exclusive responsibility, that the machines:
POWER SOURCES FOR WELDING, models: PROGRESS
1700L, POTENZA TIG 170 HF, TIG DC 200 HF, TIG AC/DC 200
HF, TIG AC/DC 315 HF satisfy all essential safety and health
requirements in conformity with regulations EN60974, 2004/108/
EC, 2006/95/EC, 2002/96/EC and 2003/11/EC in conformity with
WEEE / RoHS.
Ramiro de la Fuente
Director Manager
January, 2020
37