Servicing And Maintenance Ins- Tructions; Technical Features - STAYER WELDING S60.17L Manual De Instrucciones

5.- SERVICING AND MAINTENANCE INS-
TRUCTIONS
5.1.- Cleaning, maintenance,
sharpening.
For cleaning, always disconnect the equipment and wait at
least 10 minutes for the sake of safety regarding the discharge
of the power capacitors. Clean the housing using a slightly wet
cloth. Depending on the pollution of the work environment or at
least each 1000 hours, clean the inside with dry pressurized air,
removing the upper housing and removing dust, metal pollutants
and fluff, paying special attention to the dissipators and the fan.
The equipment does not need special maintenance by the user,
whereby careful use within the environmental limits is the best
guarantee for long years of safe service. It is recommended to
send the equipment to the technical services after each 3000
work hours or every 3 years for verification and recalibration.
5.2.- Repair services with directions.
STAYER IBERICA
Área empresarial Andalucía – Sector I
Calle Sierra de Cazorla, 7
Postal Code: 28320
Pinto (Madrid) SPAIN
List of user-replaceable parts
Due to the complexity and potential hazard, qualified intervention
is required, except for minor repairs as inspection of connections
and replacement of the standard power supply plug and revision
of the welding cables, which thus are not considered user-
replaceable parts.
6.- Regulations

6.1.- Technical features

= tension input
= current input
= current output
%
= work cycle
ON
OFF
EN60974
-
= mass
= dimensions
-
= generator power
We declare under our exclusive responsibility, that the machines:
POWER SOURCES FOR WELDING, models: S60.17L,
T100.20H, TIG DC 200 HF, T100.25PAHT, TIG AC/DC 250 HF,
T40.20PAH, TIG AC/DC 200 HF, TIG AC/DC 315 HF satisfy
all essential safety and health requirements in conformity with
regulations EN60974, 2004/108/EC, 2006/95/EC, 2002/96/EC
and 2003/11/EC in conformity with WEEE / RoHS.
Ramiro de la Fuente
Director Manager
January 5, 2015
All manuals and user guides at all-guides.com
ENGLISH
38
7.- Connections of S60.17L TIG / LIFT ARC
lubrication,
1. Positive welding output terminal (+).
Connect the working cable to the positive welding output terminal.
2.- Negative welding output terminal (-).
Connect TIG torch to the negative welding output terminal (-).
3.- Gas cylinder.
4.- Cylinder valve.
Open cylinder valve slightly so that gas flows and blows earth
out of the valve. Close valve.
5. Regulator / Flow meter.
6. Flow adjustment.
The typical flow is (15 cubic feet per hour) 7.1 L/min.
Connect the gas hose for the torch to the regulator / flow meter.
7. Gas valve.
The valve controls the pre-gas and the post-gas flow. Open the
valve at the torch just before welding.
8.- Connection for conventional welding
1. Negative welding output terminal (-)
Connect the working cables to the negative welding output
terminal.
2. Positive welding output terminal (-)
Connect the electrode carrier to the positive welding output
terminal.
38
(negative electrode, direct polarity) (Fig, 7)
(positive electrode, reverse polarity)
(Fig. 8)