Makita HP331D Manual De Instrucciones página 5

ENGLISH (Original instructions)
SPECIFICATIONS
Model:
Drilling capacities
Fastening capacities
No load speed
Blows per minute
Overall length
Rated voltage
Net weight
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heavi-
est combination, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
Battery cartridge
Charger
• Some of the battery cartridges and chargers listed above may not be available depending on your region of
residence.
WARNING:
Only use the battery cartridges and chargers listed above. Use of any other battery cartridges
and chargers may cause injury and/or fire.
Intended use
The tool is intended for impact drilling in brick, brickwork
and masonry. It is also suitable for screw driving and
drilling without impact in wood, metal, ceramic and
plastic.
Noise
The typical A-weighted noise level determined accord-
ing to EN62841-2-1:
Sound pressure level (L
Sound power level (L ) : 92 dB (A)
WA
Uncertainty (K) : 3 dB(A)
NOTE: The declared noise emission value(s) has
been measured in accordance with a standard test
method and may be used for comparing one tool with
another.
NOTE: The declared noise emission value(s)
may also be used in a preliminary assessment of
exposure.
Masonry
Steel
Wood
Wood screw
Machine screw
High (2)
Low (1)
High (2)
Low (1)
) : 81 dB(A)
pA
D.C. 10.8 V - 12 V max
BL1015 / BL1016 / BL1020B / BL1021B / BL1040B / BL1041B
DC10SA / DC10SB / DC10WC / DC10WD / DC18RE
WARNING:
Wear ear protection.
WARNING:
The noise emission during actual
use of the power tool can differ from the declared
value(s) depending on the ways in which the
tool is used especially what kind of workpiece is
processed.
WARNING:
Be sure to identify safety mea-
sures to protect the operator that are based on an
estimation of exposure in the actual conditions of
use (taking account of all parts of the operating
cycle such as the times when the tool is switched
off and when it is running idle in addition to the
trigger time).
Vibration
The vibration total value (tri-axial vector sum) deter-
mined according to EN62841-2-1:
Work mode: impact drilling into concrete
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Work mode: drilling into metal
Vibration emission (a
Uncertainty (K) : 1.5 m/s
5 ENGLISH
HP331D
8 mm
10 mm
21 mm
5.1 mm x 63 mm
M6
-1
0 - 1,700 min
-1
0 - 450 min
-1
0 - 25,500 min
-1
0 - 6,750 min
201 mm
1.1 - 1.3 kg
2
) : 8.0 m/s
h,ID
2
2
) : 2.5 m/s
h,D
2