Fagor 8H-175AX Manual De Instrucciones página 41

OPERATION
Electronic programmer
- delection sensor
MENU
> - sensor Plus
< - sensor Minus
- timer
- function symbols
The electronic prgrammer is equipped with
electronic sensors which are switched on by
touching or pressing the sensor surface for at
least one second.
Each sensor reaction is confirmed by the beep.
Keep the sensor surface clean at all times.
Setting the time
After connection to the mains or reconnec-
tion after a power cut the display shows flash
lPress sensor
MENU
show ,
lset the time using sensors > and <.
7 seconds after the time has been set the new
data will be saved.
Caution!
If the correct time is not set then proper opera-
tion of the oven is not possible.
, then the display will
Timer
The timer can be activated at any time, regard-
less of the status of other functions. The timer
can be set for from 1 minute to up to 23 hours
and 59 minutes.
To set the timer you should:
lPress sensor
MENU
show flashing ,
lset the timer using sensors > and <.
The time set is shown on the display and the
signal function is on.
lPress sensor
MENU
off the signal, the signal function will go out
and the display will show the current time.
Caution!
If the alarm signal is not turned off manually,
it will be turned off automatically after approx.
7 minutes.
, then the display will
, < or > in order to switch
41