Philips HR1367/01 Manual Del Usuario página 10

EnglisH
10
4 Immerse the whisk completely in the ingredients. To avoid splashing, start processing at
normal speed by pressing the normal speed button. (Fig. 14)
5 Continue with turbo speed after approx. 1 minute by pressing the turbo speed button.
cleaning (Fig. 15)
Do not immerse the motor unit, the whisk coupling unit or the lid of the bowl in water. Clean
these parts with a moist cloth.
Never use scouring pads, abrasive cleaning agents or aggressive liquids such as petrol or acetone
to clean the appliance.
Clean the blender bar blades, the blade unit and the combination disc very carefully. Their cutting
edges are very sharp.
1 Unplug the appliance.
2 Press the release buttons on the motor unit to remove the blender bar, the whisk coupling
unit or to detach the motor unit from the lid of the bowl.
3 Remove the detachable parts, if any.
4 See the separate cleaning table for further instructions.
5 Put the protective cover on the blade unit after cleaning.
Environment
- Do not throw away the appliance with the normal household waste at the end of its life, but
hand it in at an official collection point for recycling. By doing this you help to preserve the
environment (Fig. 16).
guarantee and service
If you need service or information or if you have a problem, please visit the Philips website at
www.philips.com or contact the Philips Consumer Care Centre in your country (you find its
phone number in the worldwide guarantee leaflet). If there is no Consumer Care Centre in your
country, go to your local Philips dealer.
storage
1 Put the blade unit and the combination disc on the tool holder and store them in the bowl.
2 Place the lid on the bowl.
troubleshooting
This chapter summarises the most common problems you could encounter with the appliance. If
you are unable to solve the problem with the information below, contact the Consumer Care
Centre in your country.
Problem
The appliance does not
work.
Solution
This appliance is equipped with overheat protection. If the appliance
overheats, it switches off automatically. Unplug the appliance and let
it cool down for 5 minutes. Then put the mains plug back into the
wall socket and switch on the appliance again. Please contact your
Philips dealer or an authorised Philips service centre if the overheat
protection is activated too often