Classic Phono TT-10 Manual De Usuario página 9

Phono Mode
1. Turn the power & volume control knob clockwise.
2. Place a record on the turntable platter and select the desired speed (33/45/78) according to the record. NOTE: when
playing a 45RPM record, use the included 45RPM adapter located in the holder near the tone arm.
3. Open the tonearm lock to release the tonearm. Push the lift lever backward to raise the tonearm and gently move the
tonearm to the desired position over the record. The turntable will begin to spin when the arm is moved toward the
record. Push the lift lever forward to lower the tonearm slowly onto the desired position on the record to begin playing
the record. Please note: The record will begin to spin only when the tonearm is moved toward the record if the Auto
Stop is turned on.
4. If the AUTO STOP ON/OFF Switch is turned ON, the record will stop automatically when finished (For some few vinyl
records, it will stop when it does not come to the end OR it will not stop when it comes to the end.). If Auto Stop
Control is turned OFF, record will NOT stop automatically when finished.
Remark: During the phono mode, please make sure that the AUX IN jack was not plugged in with the audio
cable.
Line-in Mode
Connect your iPod, MP3 player, mobile phones etc. to the AUX IN port with a 3.5mm-3.5mm audio cable (not included).
You can enjoy the music of iPod, MP3 player, mobile phones etc. at the turntable player.
Turn the volume control knob to adjust the volume.
HOW TO REPLACE THE NEEDLE
To replace the needle, please refer to the instructions below.
Removing the needle from the cartridge
1. Place a screwdriver at the tip of the stylus and push downward as shown in direction "A".
2. Remove the stylus by pulling the stylus forward and pushing downward.
Installing the Stylus
9