Entering New Timings; Power Saving Function; Plug And Play; Use Of The Tilt-Swivel - Sony Trinitron Multiscan300sf Manual De Instrucciones

Entering New Timings

When using a video mode that is not one of the 10 factory
preset modes, some fine tuning may be required to optimize
the display to your preferences. Simply adjust the monitor
according to the preceding adjustment instructions. The
adjustments will be stored automatically and recalled
whenever that mode is used.
A total of 15 user-defined modes can be stored in memory.
If the 16th mode is entered, it will replace the first.

Power Saving Function

This monitor meets the power saving guidelines set by the
E S
International NERGY TAR Program as well as the more
stringent TCO92 803299 (NUTEK) guidelines. It is capable
of reduced power consumption when used with a computer
equipped with Display Power Management Signaling
(DPMS). By sensing the absence of the sync signal coming
from the computer, it will reduce the power consumption as
follows:
CAUTION: The Power Saving function will automatically
put the monitor into Active-off state if the power
switch is turned on without any video signal
input. Once the horizontal and vertical syncs are
sensed, the monitor will automatically return to
its Normal operation state.
Power
State
consumption
Normal
1
100%
operation
Standby
approx.
2 (1st step of
70%
power saving)
Suspend
approx.
3
(2nd step of
10%
power saving)
Active-off
approx.
4 (3rd step of
4%
power saving)
0%
5 Power-off
10
Required POWER
u Power
resumption SAVING
indicator
time indicator
— off green on
approx.
orange on green on
3 sec.
approx.
orange on green on
3 sec.
approx.
orange on off
10 sec.
—
off off

Plug and Play

This monitor complies with the DDC
DDC2AB which are the Display Data Channel (DDC)
standards of VESA.
When a DDC1 host system is connected, the monitor
synchronizes with the V. CLK in accordance with the VESA
standards and outputs the EDID (Extended Display
Identification Data) to the data line.
When a DDC2B or DDC2AB host system is connected, the
monitor automatically switches to each communication.
DDC TM is a trademark of Video Electronics Standard
Association.

Use of the Tilt-Swivel

With the tilt-swivel, this unit can be adjusted to be viewed at
your desired angle within 90˚ horizontally and 20˚ vertically.
To turn the unit vertically and horizontally, hold it at its
bottom with both hands.
15°
45°
5°

Damper Wire

Using a white background, very thin horizontal stripes on
the screen are visible as shown on the illustration. These
stripes are damper wires. These wires are attached to the
aperture grille inside the Trinitron tube and are there to
damp vibrations of the aperture grille in order to prevent
them from influencing to the picture quality.
Damper wire
TM
1, DDC2B and
45°
Approx. 8 cm
Approx. 8 cm