Manuales relacionados para Truper Expert SDS MAX MADE-6NX
Resumen de contenidos para Truper Expert SDS MAX MADE-6NX
- Página 1 Instructivo de Demolition hammer Joules 6 kg SDS MAX Impact energy Applies for: Code Model 100890 MADE-6NX MADE-6NX Read this manual thoroughly CAUTION before using the tool.
-
Página 2: Tabla De Contenido
Contents CAUTION Technical Data Power requirements To gain the best performance of the tool, prolong the duty life, General power tool safety warnings make the Warranty valid if necessary, and to avoid hazards Safety warnings for the use of of fatal injuries please read and demolition hammer drills understand this Manual before using the tool. -
Página 3: Technical Data
Technical Data MADE-6NX Code 100890 Description 6 kg Demolition hammer SDS MAX Chuck SDS max Voltage 127 V~ Frequency 60 Hz Current 10 A Power Impact energy 1200 W 14 Joules Weight 6 kg Number of impacts Impact: 3 100 strokes / min Work cycle 50 minutes work per 20 min rest. -
Página 4: General Power Tool Safety Warnings
General power tool safety warnings WARNING! Read carefully all safety warnings and instructions listed below. Failure to comply with any of these warnings may result in electric shock, fire and / or severe damage. Save all warnings and instructions for future references. -
Página 5: Safety Warnings For The Use Of
Safety warnings for the use of Hammer Drills Choose the appropriate drill or attachment While operating the hammer drill CAUTION • The tool is designed to work with bits CAUTION • Hold the tool by its handle and by or accessories with SDS-max shanks. Choose the the auxiliary handle. -
Página 6: Parts
Parts SDS max Oil deposit Vibration Continuous Chuck collar cover absorber use button Trigger switch Ring for adjusting the accessory angle LED power indicator Spare carbon brushes Auxiliary Anti-skid handle handle Power cord Fan and carbon protection brushes cover Grease Power tube cord... -
Página 7: Start Up
Mounting and adjustments Mounting accessories CAUTION To prevent accidents, confirm that the switch is turned off and disconnect the plug from the power supply. WARNING Always wear gloves when changing accessories. They can become extremely hot during operation. • Clean the drill bit shank (A) and apply grease before inserting it. •... - Página 8 Start up Chisel angle adjustment • The chisel can be adjusted in 12 positions. Depending on the job to be done. • Insert the chisel into the chuck as shown on page 7. • Push forward and turn the ring (A) to change the chisel to the desired position.
-
Página 9: Maintenance
Maintenance Cleaning and Care Lubrication • Clean the machine with a soft cloth, dampened with soap • The hammer drill crankshaft is lubricated with low and water, preferably after each use. viscosity grease so that it can be used for a long period of •... -
Página 10: Notes
Notes ENGLISH... -
Página 11: Authorized Service Centers
In the event of any problem contacting a Authorized Service Center, please see our webpage www.truper.com to get an updated list, or call our toll-free numbers 800 690-6990 or 800 0187-8737 to get information about the nearest Service Center. DE TODO PARA LA CONSTRUCCIÓN FIX FERRETERÍAS... -
Página 12: Warranty Policy
. Transportation costs resulting from compliance of this warranty will be covered by For questions or comments, call 800-690-6990. Made in China. Imported by Truper S.A. de C.V. Parque Industrial 1, Jilotepec, Edo. de Méx. C.P. 54240 Stamp of the business.