Product Setup - D-Link SharePort Go II Guía De Instalación Rápida

PrODUCT SETUP

CoNNeCtING YoUr eQUIPMeNt
depending on your equipment, the dIR-508l can be set up easily from any device with Wi-Fi and a
web browser.
Modem
Laptop
Router
Laptop
3G/4G
Adapter
Router
HotSpot
Laptop
Router
CoNNeCtING to the DIr-508L
Step 1
turn on the dIR-508l by sliding the on/oFF/charge switch to ON.
Step 2
on your pc or mobile device, connect to the dIR-508l's wireless network.
By default, the settings are:
- Wi-Fi network name (ssId): DIR508L
- password: (leave this blank)
Step 3
once connected, open a web browser on your mobile device or computer and type
http://dlinkrouter.local. or http://dlinkrouter in the address bar.
Step 4
at the login page, enter the admin password. By default, it should be left blank. click Log In.
If the password is not blank or you have forgotten the password, reset the router
by pressing the RESET button with a pin for 5 seconds or more, then release.
DIr-508L
Using a Wired Ethernet Connection:
connect your dsl/cable modem or wired Internet line to the
dIR-508l with an ethernet cable.
Using a 3G/4G USB Adapter:
You will need a compatible 3G/4G usB adapter with an active sIm
card. please check your local d-link website for more information.
plug the 3G/4G usB adapter into the usB port on the dIR-508l.
Connecting to a Wi-Fi Hotspot:
You will need the Wi-Fi network name and password of the hotspot
you want to connect to.
3