Configuration - D-Link SharePort Go II Guía De Instalación Rápida

PrODUCT SETUP

CoNFIGUratIoN

after logging in, you will see a status page. If the Internet icon
If the Internet icon
Using a Wired Ethernet Connection:
enter the username and password given to you by your Internet service provider.
Using a 3G/4G USB Adapter:
If your sIm requires a pIn, enter it and click Save. If necessary, the wizard may ask you to
enter the apn, dial-up number, username, and password details given to you by your service
provider.
Connecting to a Wi-Fi Hotspot:
select an available hotspot and enter its password to connect.
MaNaGING YoUr CoNNeCtIoNS
connection configurations will be automatically saved as Internet profiles for future use. the
dIR-508l will connect to them automatically when they are available. If you have more than one
connection available, you can manually select the connection you wish to use.
to select a connection:
- Go to Settings>Internet Profiles
- From the profile list, you can select the radio button next to your profile name to use this
connection.
For more details on how to add, delete, or edit profiles, please refer to Internet Profiles in the user
manual.
CHArGING
CharGING other DeVICeS
the shareport Go II can charge your mobile devices on the go, including high-power devices such
as ipads.
Step 1
slide the on/oFF/cHaRGeR switch of the dIR-508l to CHARGER.
Step 2
plug your device into the usB port of the dIR-508l, check your device to make sure it is now
charging.
Note: If the battery led is red, you will need to charge the dIR-508l. actual usable capacity may
vary depending on charging conditions.
4
is grey and there is a
is blue, the device is ready for use!
icon, click on the icon and follow the steps below:
DIr-508L