Digital Display - Tripp-Lite AG-00D5 Serie Manual Del Propietário

4. Digital Display

1
Source Status LEDs: Lit LED patterns indicate which source is preferred, which source is
available for use, and which source is currently being used. See Source Status LED
Indicators section for an explanation of the LED patterns.
2
Breaker Trip LED: Lit when a breaker has tripped.
3
3-Digit Display: Shows measured or calculated values such as Amperage, Kilowatts, Voltage,
Power Unbalance Percentage, Frequency, Power Factor and Temperature.
4
Enter Button: When a menu is selected using the Mode Button, the Enter Button scrolls
through the submenus within each category. Submenus are shown by the Indicator LEDs.
Note: Pushing the Enter and Mode button simultaneously for 2 seconds displays the IP address.
5
Indicator LEDs: Lit LED indicates which value is being displayed on the 3-digit screen.
Amps (A): The input current on the selected Source Input (A# or b#) or Output Load Circuit
(C#) is displayed in amps.
Wattage (kW): The Output Power for the selected Output Load Circuit (C#) or Total Output
Power (OP) is displayed in kW.
Voltage (V): The Source A or B Input Phase-to-Phase voltage (A# or b#) or Output Load
Circuit voltage (C#) is displayed in volts.
Frequency (Hz): Source Input A or B frequency is displayed in Hz.
Power Factor (PF): Output Load power factor is displayed as a decimal (from 0 to 1.00).
15-05-226-933363.indb 8
3
1 2
5 6
4 7
8
8
6/29/2015 9:08:09 AM