Front Panel - Fender Vibro Champ XD Instrucciones De Funcionamiento

The Vibro-Champ® of the 1960s and '70s was an upgraded
version of the venerable Fender Champ® amp. Its small
size, low output, and great tube tone (including tremolo
effect) has been enjoyed by countless guitarists...beginners
and seasoned pros alike. The Vibro-Champ XD amplifier
takes that winning formula into a new era by combining
a real tube amp with versatile digital voicing and effects.
Recording and practice sessions come alive with the Fender
Vibro-Champ XD.
INPUT
GAIN VOLUME
A . INPUT—Plug your guitar in here.
B . GAIN—Controls preamp volume. Also controls signal
distortion, except when VOICE 16 {D} is selected.
C . VOLUME 1—Use to set the loudness of the amplifier
after adjusting GAIN {B}.
D . VOICE—Select one of 16 amplifier voicings (see next
page).
NOTE: Use the extreme flexibility of the Voice knob
wisely! Treble harshness or boomy bass tones can be
avoided by using the right guitar settings and playing
style for a particular amp voicing.
E . TREBLE/BASS—Adjusts the high- and low-frequency
tone characteristics of the amplifier.
F . FX LEVEL—Adjusts the intensity of the active effect.
G . FX SELECT—Selects the active effect (see next page).
H . POWER JEWEL—Indicates when the unit is on.

Vibro-champ Xd amplifier

front panel

� � �
� ��
� � �
� ��
�
��
�
��
�
��
��
VOICE TREBLE BASS
f e n d e r . c o m
• 5 Watts into 4 ohms
• Digital Signal Processing
• 16 Effects "F/X" settings
• 16 Amplifier "VOICE" settings
• Line Output—for recording or sound reinforcement
Thank you for choosing Fender®
World's most popular instrument amplifiers—since 1946.
F/X LEVEL F/ X SELECT
I . POWER CORD SOCKET—Connect to a grounded outlet
using the included power cord in accordance with the
voltage and frequency ratings specified on the rear
panel of your amplifier.
J . POWER SWITCH—Switches the amplifier ON–OFF.
K . FUSE—Protects the unit in case of electrical faults.
Replace only with the type and rating specified on the
rear panel of your amplifier.
L . SPEAKER OUT—Connection for the internal speaker or
an external speaker (4Ω/5W minimum).
Use only a standard 1/4" mono plug.
M . LINE OUT—Connect your recording or sound
reinforcement equipment here.
Use only a standard 1/4" mono plug.
V I N TA G E M O D I F I E D T U B E A M P L I F I E R
rear panel