Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
2.
Wire unit per Wiring Diagram (refer to electrical
section).
3.
Attach rear wall mount tether to splice box mounting
screw, like what is shown in Figure 4.
4.
Mount cylinder housing assembly to wall by tightening
screws on top and bottom of arm base to 17 IN/LBS
torque to engage mounting plate.
5.
Installer must apply silicone compound around entire
perimeter of the mounting arm where it mates to the
mounting surface.
6.
For Wet Location/IP66 installer must apply silicone
compound around the entire perimeter of the mounting
arm where it mates to the cylinder housing.
DMX Wiring Instructions:
Ceiling Mount Version:
1.
Loosen and remove the 4 screws on top of cylinder.
Remove the cylinder top to access the driver bracket
assembly. (Figure 5.)
Figure 5.
2.
Fish DMX Cables (supplied by others) through hole in
mounting plate or mounting arm leaving approximately
ten inches of wire.
3.
Proceed to mount the cylinder to the J-Box, keeping
the top disconnected from the cylinder (Refer to
the installation section of this instruction manual for
details).
4.
The driver's push in connectors can be accessed by
either removing the splice cover or the driver itself from
driver bracket by removing the indicated set screw.
(Figure 6.)
5.
Connect DMX cables to Driver(s) per DMX wiring
standards.
6.
Secure the driver or splice cover back to the driver
bracket with the set screw.
7 .
Reconnect the cylinder top to the cylinder using the 4
top screws.
Wiring Diagrams and Instructions – LER*4B, LESQ*4B, LER*6B, & LESQ*
Cooper Lighting Solutions
Set Screw
Figure 6.
Up-Down Version:
1.
Remove wall mount arm from fixture by removing (2)
#8 screws
2.
Remove internal driver subassembly from fixture.
(Figure 7 .)
Figure 7.
3.
Remove the driver or the splice cover to access the
driver push in connectors. (Figure 6.)
4.
Feed the DMX cables through the wall mount arm and
into the cylinder leaving enough excess cable to wire
the driver from outside of the cylinder (See length table
in the introduction sheet for overall fixture length).
5.
Connect DMX cables to drivers per DMX wiring
standards.
6.
Insert the driver sub assembly back into the cylinder
making sure all cables are rerouted back through the
wall mount arm.
7 .
Reconnect the wall mount arm to the cylinder with the
#8 screws
8.
Mount fixture to the wall following the wall mount
instructions in the installation section.
IB520075ML
Splice Cover
Set Screw
#8 Wall Mount
Screws
Installation instructions
3
Publicidad
Tabla de contenido
