General Set Up - Craftsman CMXEVBCB1260L Manual De Instrucciones

Assemble as follows:
1. With cord disconnected from the receptacle and tank
cover removed, turn tank upside-down so bottom is facing
up.
2. Take caster feet 4 and place into slots on tank. Fig. 1.
Fig.1
3. Secure caster feet 4 to tank with screws 9 provided.
Fig. 2.
Fig. 2
4. Insert casters 5 into caster feet 4 by placing the caster
stems into the holes provided. Apply pressure and twisting
motion until casters 5 snap into place. Fig. 3.
Fig. 3
5. Return tank to upright position.

GENERAL SET UP

6. Before replacing tank cover, refer to Dry Pick Up or Wet
Pick Up Operation in user manual to ensure you have the
proper filters installed for this cleaning operation.
7. Replace tank cover, and apply pressure with thumb to
each latch until it snaps tightly into place. Make certain all
lid latches are clamped securely.
8. Insert hose 12 into inlet of tank 2 . Do not over-tighten.
9. Attach the extension wands 11 to the accessory end of
the hose. Twist slightly to tighten the connection. Fig. 4.
Fig. 4
10. Attach one of the cleaning accessories (depending on
your cleaning requirements) on the extension wands 11 .
Twist slightly to tighten the connection. Fig. 4.
11. Plug the cord 7 into the wall outlet. Your cleaner is
ready for use. I = ON, O = OFF
PORTABLE BLOWER OPERATION

WARNING:
PROTECTION TO PREVENT ROCKS OR DEBRIS
FROM BEING BLOWN OR RICOCHETING INTO THE
EYES OR FACE WHICH CAN RESULT IN SERIOUS
INJURY.
Blower Safety
12. Never operate the portable blower 3 in wet or damp
conditions. Do not use in rain.
13. Keep area of operation clear of all persons, particularly
small children and pets.
14. Dress properly. Do not wear loose clothing or jewelry.
Always wear substantial footwear and long pants. Secure
loose hair with a hat or hair net to avoid hair being
caught in moving parts.
15. Never blow debris in direction of bystanders.
16. Do not overreach or use blower 3 from unstable surface
such as ladders, trees, steep slopes, roof tops, etc. Always
be sure of your footing.
17. Inspect the area before using the blower 3 . Remove all
debris and hard objects such as rocks, glass, wire, etc. that
can be blown or cause damage during operation.
18. Always wear a respirator or face mask when working in
dusty environments.
19. Keep vents clean and clear of dirt and debris.
ENGLISH
ALWAYS WEAR EYE
4