Publicidad
ENGLISH - 12
Treadle Sensor Installation Description with Diagrams (Proper Replacement of Treadle Sensor)
1
1. Remove the 4 screws on the treadle sensor
plate.
3. Check the relative position of the sensor
and light blocker. If the light blocker is in a
position that has blocked the light when the
treadle is not pushed down, the motor will
rotate. Adjust the blocker position if necessary
by loosening the screw and tightening it again.
3
www.endurosaves.com
2
2. Check the channel sensor. It should have
a red light when the cable is connected to the
motor circuit board and the motor is powered
on. Check the cable connection if there is no
red light.
4. Change the sensor if necessary by
unscrewing and reinstalling the two screws.
Then connect the cable to the motor circuit
board. The red light should appear when the
motor is powered on indicating it is working.
4
Publicidad
