Publicidad
Installation of Positioner on SM645-1P & SM645-2P
1. Be sure the female power cord is disconnected from the power inlet socket.
2. Remove the screw on the machine pulley. Install the sensor adapter (supplied) onto the pulley
with the adapter screw (supplied).
3. Install the positioner sensor onto the sensor adapter and fasten with the two set screws. Install
the positioner sensor rod into the groove on the sensor and lock the rod onto the machine with
the nut (supplied).
4. Connect the sensor signal wire plug to the socket on the rear panel of the motor box.
5. Plug the power cord from the switch box into the power input socket on the rear panel of the
motor.
6. Power ON the motor.
7. Check the position of the needle with the motor working.
8. If the needle is incorrect, loosen the set screws on the sensor and move the belt pulley until the
sensor light shows for correct needle position by illuminating.
9. WARNING:
DO NOT MAKE THE SENSOR RUN DURING THIS POSITIONER SETUP
PROCESS.
10. Make sure positioner is correct. Then tighten the two (2) set of screws on the sensor.
www.endurosaves.com
ENGLISH - 7
Publicidad
