Publicidad
Wiring
For 110 volt single phase motor follow the diagram below:
For 220 volt single phase motor follow the diagram below:
Note: When wiring the motor to the power source, connect both the black and white wires to
achieve 220 Volts (green to ground). If you are in an area (China / Europe) that supplies 220 Volts
from a single lead, then connect the power source to the black wire. The white wire will then be the
neutral and the green wire will be the ground.
Setting Up
Turn on the power switch located on the switchbox. The display
will show "P.d", which means the motor is in "ready" status,
ready to work or be set.
Ready Status
"P.d" is the factory default "ready" status setting and means the
needle position setting is POSITION DOWN. "P.d" is "ready"
status while default setting is not changed.
Once the needle position setting is changed to "P.u" (which
means the needle position setting is POSITION UP), then "P.u"
becomes the "ready" status.
www.endurosaves.com
ENGLISH - 3
default "ready" status
default "ready" status
Either "P.d" or "P.u" will indicate
"ready" status, depending on
how the needle position is set.
alternate "ready" status
Publicidad
