Potential For Radio/Television Interference; Troubleshooting - HoMedics BPA-250 Manual De Instrucciones

POTENTIAL FOR RADIO/TELEVISION
INTERFERENCE
For USA only:
This product has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of FCC rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. The product generates,
uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If the product does
cause harmful interference to radio or television reception, which can be
determined by turning the product on and off, the user is encouraged to
try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the product and the receiver.
• Connect the product into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
For Canada only:
This digital apparatus does not exceed the Class B limits for radio noise
emissions from digital apparatus as set out in the interference-causing
equipment standard entitled "Digital Apparatus", ICES-003 of the
Canadian Department of Communications.
Cet appareil numérique respecte les limites de bruits radioeléctriques
applicables aux appareils numériques de Classe B prescrites dans la
norme sur le matériel brouilleur: "Appareils Numériques", ICES-003
édictée par le ministre des communications.
29

TROUBLESHOOTING

If any abnormality arises during use, please check the following points
POSSIBLE
SYMPTOMS
CAUSES
Unit does not turn on Batteries have
when the run down.
START/STOP
button is pushed.
Battery polarities
have been positioned
incorrectly.
EE measurement Cuff has been placed
error symbol shown incorrectly.
on display or the
blood pressure value
Did you talk or move
is displayed exces-
during measurement?
sively low
Shaking of the arm
(or high).
with the cuff on.
E1 error symbol Air circuit abnormality.
shown on display Cuff tube may not be
plugged into monitor
correctly.
E2 error symbol Inflation pressure
shown on display exceeding 300 mmHg.
E3 error symbol Data error.
shown on display
CA Appears on
Recalibration alert.
display
Note: If the unit still does not work, contact HoMedics Consumer
Relations. Under no circumstance should you disassemble or
attempt to repair the unit by yourself. Contact information for
HoMedics Consumer Relations Department can be found on
the warranty page.
CORRECTION
Replace them with
four new AA
alkaline batteries.
Re-insert the batteries
in the correct posi-
tions.
Wrap the cuff proper-
ly so that it is posi-
tioned correctly.
Measure again. Keep
arm steady during
measurement.
Check cuff connection.
Measure again.
Switch the unit off,
then measure again.
Remove and reload
the batteries.
Refer to page 26 for
more information.
30