Tabla de contenido
Publicidad
compatible with a variety of standard cartridges. Be sure to
remove the clear plastic cover from the cartridge before
operating the turntable.
PLATTER SETUP
WARNING: Incorrect Platter setup can lead to poor turntable
performance, platter instability or permanent motor damage.
1. Start by placing the rubber drive belt around the inner bottom
ring of the turntable platter, if it did not come preinstalled, and
check to make sure that it is not twisted or damaged.
2. Place the Platter on the center spindle and press it down
firmly. Check to make sure that it rotates uniformly and does
not wobble excessively.
3. Rotate the platter so that the one of the holes is aligned with
the Start Stop button on the front corner of the turntable. The
brass motor spindle should be visible through this hole.
4. Reach into the hole and pull the rubber drive belt off of the
inner ring, and install it over the motor spindle. Be careful not
to twist the rubber drive belt during this step. Check to make
sure the platter rotates uniformly. If the drive belt is properly
installed, there should be a slight amount of tension that
brings the platter to a stop after spinning it freely.
iTTUSB Owner's Manual V5 - Page 4
Publicidad
Tabla de contenido
