Hilti NCR 060 II-A22 Manual De Instrucciones Original página 19

2.3 Battery use and care
▶ Observe the special regulations and instructions applicable to the transport, storage and use of Li-ion
batteries.
▶ Do not expose batteries to high temperatures, direct sunlight or fire.
▶ Do not disassemble, crush or incinerate batteries and do not subject them to temperatures over 80 °C.
▶ Do not use or charge batteries that have suffered mechanical impact, have been dropped from a height
or show signs of damage. In this case, always contact your Hilti Service.
▶ If the battery is too hot to touch it may be defective. In this case, place the product in a non-flammable
location, well away from flammable materials, where it can be kept under observation and allowed to
cool down. In this case, always contact your Hilti Service.
3 Description
3.1 Product overview
3.2 Intended use
The product described is a cordless electro-hydraulic crimping tool.
It is designed for crimping connectors made of copper (Cu) or aluminum (Al).
Before use of the power tool, all live cables or other items carrying electric voltage within the area in which
the user is working must be switched off. If this is not possible, the corresponding safety precautions for
working in the proximity of live cables or equipment must be implemented and observed.
▶ Use only Hilti Li­ion batteries of the B 18 and B 22 series with this product.
3.3 Possible misuse
• Do not use this hand-held product clamped in a fixed position or as a stationary device.
• Do not use the product in heavy rain or under water.
3.4 Lithium­ion battery status display
The charge state of the Li-ion battery and malfunctions of the product are indicated by the indicator of the
Li­ion battery. The charge status of the Li­ion battery is indicated after one of the two battery release buttons
is short-pressed.
Status
4 LEDs light.
3 LEDs light.
2 LEDs light.
1 LED lights.
1 LED flashes.
2207049
*2207049*
Printed: 15.06.2018 | Doc-Nr: PUB / 5436011 / 000 / 01
1
Crimping / pressing head
@
Piston reset slider for use in case of fault or
;
emergency
Servicing and fault indicator (red LED)
=
Battery release button
%
Battery
&
Slot on both sides to fasten the Hilti retaining
(
leash
White LED to illuminate the working area
)
Control switch
+
Crimping / pressing ram (stepped)
§
Pivoting bar to open the tool head
/
Lever to lock/unlock the tool head
:
Meaning
• State of charge: 75 % to 100 %
• State of charge: 50 % to 75 %
• State of charge: 25 % to 50 %
• State of charge: 10 % to 25 %
• State of charge: < 10 %
English 13