Luminance Brands Kathy Ireland Home LK52 El Manual Del Propietario página 13

4. Installation on Luminance Brands Fans Having
Two-Piece Die-Cast Switch Housing (continued)
4.8
Insert the Light Fixture Assembly Chain through the
Center Hole in the Glass Bowl (Figure 19) .
Gently place the Glass Bowl onto the Light Fixture
Assembly (Figure 19) .
NOTE: It is critical that the fan speed control chain
is aligned with hole in the Glass Bowl for smooth
operation of the fan switch.
Install and tighten the Rubber Washer and the Thin Hex
Nut onto the Light Fixture Assembly Threaded Stud
(Figure 19) .
NOTE: It is advisable to periodically check the
tightness of the thin hex nut.
4.9
Install and tighten the Bowl Cap and the Finial Nut onto
the Light Fixture Assembly Threaded Stud (Figure 20) .
NOTE: It is advisable to periodically check the
tightness of the finial nut.
GLASS
BOWL
THREADED STUD
RUBBER WASHER
THIN HEX NUT
LED LIGHT FIXTURE
ASSEMBLY CHAIN
Figure 19
GLASS
BOWL
THREADED STUD
BOWL CAP
FINIAL NUT
LED LIGHT FIXTURE
ASSEMBLY CHAIN
13
OFF-SET
HOLE
FAN SPEED
CONTROL
CHAIN
FAN SPEED
CONTROL
CHAIN
luminancebrands.com
Please contact 1-800-777-4440 for further assistance
U.L. Model No.: LK52-1