Luminance Brands Kathy Ireland Home LK52 El Manual Del Propietario página 8

3. Installation on Luminance Brands Fans Having a
Modular Switch Housing with Center Screw
3.10
The Light Fixture Assembly Light Sockets are equipped
to accept Three 6 .5-Watt Medium Base A15 LED Bulbs
(supplied) (Figure 9) .
To Install the Three 6 .5-Watt Medium Base A15 LED
Bulbs into the Sockets, twist the Bulbs Clockwise to
secure (Figure 9) .
3.11
Insert the Light Fixture Assembly Chain through the
Center Hole of the Glass Bowl (Figure 10) .
Route the Fan Speed Control Chain through the Glass
Bowl off-set Hole (Figure 10) .
Insert the Light Fixture Assembly Chain through the
Center Hole of the Glass Bowl (Figure 10) .
NOTE: It is critical that the fan speed control chain
is aligned with hole in the Glass Bowl for smooth
operation of the fan switch.
Install and tighten the Rubber Washer and the Thin Hex
Nut onto the Light Fixture Assembly Threaded Stud
(Figure 10) .
NOTE: It is advisable to periodically check the
tightness of the thin hex nut.
LIGHT
SOCKETS
Figure 9
GLASS
BOWL
THREADED STUD
RUBBER WASHER
THIN HEX NUT
LED LIGHT FIXTURE
ASSEMBLY CHAIN
Figure 10
8
(continued)
LED MEDIUM
BASE BULBS
OFF-SET
HOLE
FAN SPEED
CONTROL
CHAIN
U.L. Model No.: LK52-1