Easy Home VC9389A Manual Del Usuario página 11

1. Plug the power cord
by switching the on/off switch
2. Step on the handle release pedal
cleaner into the cleaning position.
3. While pulling the solution release trigger
cleaner in a backwards direction towards you.
4. Release the solution release trigger and push the carpet cleaner forward
in the same path to agitate and remove dirty water and solution from the
carpet.
For heavily soiled areas, repeat as necessary.
5. To turn off the carpet cleaner, switch the on/off switch to the 0 position.
Tips for carpet cleaning
• Use a steady, moderate, forward and backwards motion.
• Always work from back to front across a room to avoid stepping on wet carpet.
• Do not make the carpet too wet. Use no more than two sets of forward and
backward strokes while releasing solution. Always follow with dry strokes;
the more the better.
• Wipe any cleaning solution from woodwork and furniture to prevent any
damage.
• Allow plenty of time for the carpet to dry and avoid walking on it until it is
dry.
• Increased air circulation (open doors, fans, etc.) or the use of a dehumidi-
fier will help the carpet dry thoroughly and prevent the growth of mold or
mildew.
• Vacuum the carpet thoroughly before cleaning it and after it has dried.
Emptying the dirty water tank
CAUTION!
Risk of injury!
Improper handling of the carpet cleaner may cause injury.
− Always unplug the carpet cleaner before emptying the
dirty water tank.
− Never remove the guarding of a moving part. Failure to do
so could result in injury to persons and would defeat the
utility of the appliance.
15 into an electrical outlet and turn it on
2 to the I position.
13 to lower the carpet
Using the carpet cleaner
11 , pull the carpet
15