14
ASSEMBLING AND PREPARING
Attaching the protection cover
1
Remove the stand before installing the TV
on a wall mount by performing the stand
attachment in reverse.
After removing the stand, push the supplied
protection cover into the opening at the bottom
of the TV until it locks in place.
This will protect the opening from accumulating
dust and dirt.
2
Secure the TV and the protection cover with
the 2 screws.
2 EA
M4 x 30
CAUTION
Make sure that the screws are fastened
y
y
completely. (If they are not fastened
securely enough, the TV may tilt forward
after being installed.)
Do not fasten the screws with too much
y
y
force; otherwise they may be worn out
and get loosened.
Protection cover
Tidying cables
1
Install the power cord holder and power cord.
It will help prevent the power cable from being
removed by accident.
2
Gather and bind the cables with the cable
holder.
CAUTION
Do not move the TV by holding the cable
y
y
holder and power cord holder, as the cable
holders may break, and injuries and damage
to the TV may occur.
Power cord holder
Cable holder