vitapur VWD9506W-POU Manual De Uso Y Cuidado página 3

3-prong wall outlet.
• Do not under any circumstances cut or remove the third (ground) prong from the power cord plug.
• Do not use an adapter plug with this appliance.
• Do not use an extension cord with this appliance. If the power cord is too short, have a qualified electrician install
an electrical outlet near the appliance.
YOUR VITAPUR® WATER DISPENSER
1. Top Cover
2. Ready-To-Dispense indicator lights:
Yellow: "flashing"
"off"
Blue: "on"
"off"
3. Child resistant safety switch
4. Hot water dispensing button (also dispenses room temperature water when Kettle feature is not activated)
5. Cold water dispensing button
6. Kettle Feature (on/off) activation button (self-illuminated)
"flashing" Heater (hot water tank) is operational.
"on" The hot water has reached optimum temperature and is ready for dispensing.
"off" Heater (hot water tank) is off,
however remaining water within the
tank may still be very hot, always
exercise caution when dispensing
and/or draining water from the hot
water tank.
7. Removable drip tray
8. Adjustable COLD water thermostat
(rear of dispenser)
9. Drain valve (rear of dispenser)
10. Condenser coils (rear of dispenser)
11. Lower front panel (filter located behind)
12. Manual shut-off valve (water inlet)
Low water level inside internal reservoir. Hot water heating system cannot be activated.
(you must replenish water supply)
Internal reservoir water level is sufficient to activate hot water heating system
The cold water has reached optimum temperature and is ready for dispensing
The cooling cycle is in progress, it is possible to dispense water during the cooling
cycle, however, optimum cooling temperature may not yet be achieved
1
6
4
3
7
11
1
2
5
L H
9
8
12
10