RIDGID SeeSnake Serie Manual Del Usuario página 12

SeeSnake
Figure 16 – Incorrect Hand Position on Push Cable
DO NOT Fold the push cable onto the sharp edge of
an entry. This can cause it to snap. Extreme caution
must be used to minimize the chance of bending the
push cable on sharp corners. This can cause push cable
failure. If the camera just does not seem to want to go
any farther, DO NOT FORCE THE CAMERA! If another
entry is available, try it, or run water down the line as ex-
plained below.
NOTE! Hands should be close to the line opening. DO
NOT catch the cable on the edge of an entry
and continue to push.
Always try to run water down the pipe undergoing
inspection. This will keep the system much cleaner, and
allow you to push noticeably farther with less friction.
This will also help you locate the bottom of the pipe. This
can be accomplished by feeding a hose with a small
amount of flow into the entry or occasionally flushing a
toilet that drains to the pipe. If the water is preventing you
from seeing an area of importance, temporarily turn it off.
When inspecting a pipe, it is usually necessary to
give a little extra push in tight turns. Back the camera
head approximately 6" (15cm) from the bend, if neces-
sary, and give it a quick push, "popping" the camera
through a turn, using the least amount of force required.
Try to be as gentle as possible, and do not hammer or
snap the camera head through corners. In many in-
stances, the best way to inspect a section of pipe is to
push the camera through quickly, then draw the camera
back home slowly and evenly. It is always easier to
control the camera when pulling than when pushing.
Make sure the sapphire window is clean prior to en -
try. In some cases a slight film of liquid detergent on the
lens helps minimize the possibility of grease sticking to
the lens port.
10
® Compact and Color Compact
Do not clear obstructions with the camera head!
This may cause premature failure to your camera
head. The SeeSnake ® is a diagnostic tool that iden-
tifies problems. Other tools should be used to make
effective repairs. It should never be used to clear ob-
structions (Figure 17).
Figure 17 – Do Not Clear Blockage with Camera Head
If local 120V (or 230V) AC power for the CCU is not
available, you can operate the system using a volt-
age converter that plugs into your vehicle's cigarette
lighter. They convert your vehicles 12 volt DC to 120
volts (or 230V) AC.
The system can travel through multiple 45 and 90
degree bends and wyes. Do not, however, try to
force it through a P-trap or Tee if there is a large
amount of resistance.
Do not attempt to remove or store push cable on the
reel solely by turning the reel itself. If for some un-
usual reason the drum should not turn, do not try to pull
the push cable out of the reel. This will force the cable to
collapse down around the hub causing unnecessary
stress on the cable.
Be careful in Tee-entries not to fold the camera
back on itself, this could cause the camera to get
caught. (See SeeSnake Tips & Tricks video.)
The camera head can get HOT!
CAUTION
When finished with your inspection, or if taking
a prolonged break in the middle of the inspection, turn
off the system. If the camera sits in a pipe, or any en-
closed environment, heat will build-up. This may lead to
the camera head overheating which will cause fuzzy
lines to appear on the monitor. In the event this hap-
pens, turn off the system, remove the camera from the
pipe (or enclosed environment) and let the camera head
cool for 10 to 15 minutes. Running water into the line will
also help cool the camera head. Always use the minimum
illumination required to maximize picture quality and to
avoid excessive heat build-up.