Troubleshooting; Icon Legend - RIDGID SeeSnake Serie Manual Del Usuario

Chart 1 Troubleshooting
PROBLEM
Garbled or jumbled video
Monitor flickers 4 times
per second
Dim monitor image
Lights, but no video
No video, no lights
Video, but no lights
White screen
Noisy picture – vertical
stripes on monitor
screen
Noisy picture – horizon-
tal stripes on monitor
screen
If further assistance is needed, please call RIDGE Tool Technical Service at
(800) 519-3456. Additional information may be available at www.ridgid.com or
www.seesnake.com

Icon Legend

Caution Symbol
Video In/Out Connector
No Video Signal
External Power Jack (15-19 VDC)
Power On/Off
Power On
Day/Night Switch
PROBABLE FAULT LOCATION
Fault within camera, cables, or Monitor Pack.
Pipe may be electrically charged or "hot". Remove camera immediately and have pipe checked by quali-
fied personnel.
Day/Night switch in night mode (depressed, B&W Only), or brightness knob turned down.
Monitor's contrast and/or brightness knobs turned down or monitor power switch is OFF.
Break in video carrying conductor (pin/socket 3) between Camera and Monitor Pack (SOS LED).
Fault within camera or Monitor Pack.
Monitor Pack or monitor screen not turned ON.
SeeSnake Interconnect Cord not fully plugged in or loose connection in system (SOS LED).
Fault in any sub-assembly.
Dimmer turned down.
Fault within camera head, LED section.
Camera exposed to excessive light.
No input video.
Contrast/Brightness improperly set.
Camera head overheated.
Transmitter is ON.
SeeSnake ® Compact and Color Compact
Battery Status
Transmitter De-activated
Transmitter Activated
Dimmer Status
MultiFunction Button Release
MultiFunction Button Hold
MultiFunction Button Press and Release
Monitor Image Invert
Camera Connector
Ground Reference
(Equipotentiality)
Double Insulated
15