Clatronic BS 1228 Instrucciones De Servicio página 39

5....-05-BS 1228
1. Insert the vacuum hose in the opening in the dust bag compartment until it
locks in mechanically.
2. To release the hose, press the button on the vacuum hose.
3. Keep the button pressed and pull out the hose.
4. Insert the vacuum tube into the handle if required.
1. Fit on the accessory.
2. Unwind the necessary length of cable and insert the plug in a duly installed
230V/50Hz protective contact socket.
3. Set the vacuum power with the vacuum power regulator.
4. Vacuum at a steady speed. There is no need to exert pressure.
5. Attention: pay attention to the range that can be covered with the cable length.
Vacuum power regulator
Low vacuum power:
Medium vacuum power:
High vacuum power:
Cable winding device:
Pull out the cable up to the maximum length indicated with the yellow mark. Never
pull the cable out up to the red mark as the cable winding can be damaged. Said
damages are not covered by the warranty.
Winding
Press the cable winding button and guide the cable. Hold the cable to avoid wrap-
ping.
Telescope Vacuum Pipe:
• The height-adjustable vacuum pipe enables individual alignment to your height.
• Unlock the coupling by pressing the key in the direction of the arrow
• Slide the vacuum pipe to the desired length.
• To lock the device, release the key until you hear it lock in place.
Nozzle accessories:
Note: The accessories are in the accessories drawer (8) under the machine
Floor nozzle:
Crevice nozzle:
04.12.2002 9:43 Uhr
Start-up
Using the Appliance
For curtains and delicate fabrics
For long-pile velour carpets and textile flooring
For sturdy rugs and floors
For cleaning carpets or smooth surfaces.
To vacuum corners and slits
Seite 39
GB
39