Hilti NCT IS 053-A22 Manual De Instrucciones página 19

Status
4 LEDs light.
3 LEDs light.
2 LEDs light.
1 LED lights.
1 LED flashes.
Battery state of charge cannot be displayed while the control switch is pressed and for up to 5 seconds
after releasing the control switch. If the LEDs of the charge state indicator flash, follow the instructions
in the 'Troubleshooting' section.
3.5 Items supplied
Cutting tool, operating instructions.
Other system products approved for use with this product can be found at your local HILTI STORE or online
at: www.hilti.group
4 Technical data
Rated voltage
Weight in accordance with EPTA Procedure 01 including
batteryB22⁄8.0
Max. cable diameter
Max. cutting capacity
Storage temperature
Ambient temperature for operation
4.1 Noise information and vibration values in accordance with EN 60745
The sound pressure and vibration values given in these instructions were measured in accordance with a
standardized test and can be used to compare one power tool with another. They can also be used for a
preliminary assessment of exposure. The data given represents the main applications of the power tool.
However, if the power tool is used for different applications, with different accessory tools, or is poorly
maintained, the data can vary. This can significantly increase exposure over the total working period. An
accurate estimation of exposure should also take into account the times when the tool is switched off, or
when it is running but not actually being used for a job. This can significantly reduce exposure over the
total working period. Identify additional safety measures to protect the operator from the effects of noise
and/or vibration, for example: Maintaining the power tool and accessory tools, keeping the hands warm,
organization of work patterns.
Noise values
Sound (power) level (L
Uncertainty for the sound power level (K
Emission sound pressure level (L
Uncertainty for the sound pressure level (K
Vibration values
Total vibration (during operation) (a)
Uncertainty (K)
4.2 Battery
Battery operating voltage
Ambient temperature for operation
*2207047*
)
WA
)
WA
)
pA
)
pA
2207047
Meaning
State of charge: 75 % to 100 %
State of charge: 50 % to 75 %
State of charge: 25 % to 50 %
State of charge: 10 % to 25 %
State of charge: < 10 %
NCT IS 053-A22
21.6 V
3.8 kg
50 mm
1000 MCM Al/Cu cable, 2" (50
mm) outside diameter
−20 ℃ ... 70 ℃
−17 ℃ ... 60 ℃
80 dB(A)
2.5 dB(A)
70 dB(A)
2.5 dB(A)
2.5 m/s²
1.5 m/s²
21.6 V
−17 ℃ ... 60 ℃
English 15