Loewe Xelos Rack Instrucciones De Montaje página 7

Wiring your Xelos SL 32 and SL 37 and Xelos A 32 and A 37 TV to the Xelos Rack
Procedure
Your screen is mounted on the Xelos Rack.
Figure 2 shows the wiring of a Xelos A37 with a TV set placed in the rack as
an example.
Place the necessary and desired additional equipment in the rack.
Take the socket strip provided.
Pull the backing foil off the bottom of the socket strip.
Stick the socket strip in the position in the rack marked by arrow D in fi g. 2.
Lay the power cable of the socket strip as shown.
Your screen requires two or three connecting cables depending on the ver-
sion (1 power cable and antenna cable or power cable, system cable 1 and
system cable 2).
Plug the cables into the sockets on the screen fi rst.
If connecting cables are visible we recommend you to lay the cables in a
fabric tube in this area. See also the information overleaf.
Secure the plugs where available with their retaining screws on
the screen.
Fix the cables in the cable clip on the screen.
Then lay the cables in the cable recess of the Xelos Rack (fi g. 2, arrow A)
down further. Do not pull the cables down too tightly.
Otherwise they will obstruct rotation of the screen on the Xelos Rack.
You can fi x the cables additionally in the cable recess in the rack with the
cable tie provided (fi g. 2, arrow G).
Handling of the three self-adhesive cable ties, fi g. 2, arrows C,
arrow G.
Remove the backing strip (underside of cable tie).
Stick the cable tie to the rack as suggested.
Fasten the cables in the cable tie as shown.
Feed the plugs of the cables through the openings (arrow E and
F) in the rack to the set auxiliary equipment.
Note
Please see the operating manual of your set for a detailed description of
the assignment of sockets and cables.
fi g. 2
G
C
A A A A
F
E
C
7