Wiring Your Xelos A 42 Tv To The Xelos A 42 Rack - Loewe Xelos Rack Instrucciones De Montaje

Wiring your Xelos A 42 TV to the Xelos A 42 Rack

Procedure
Your screen is mounted on the Xelos A 42 Rack.
Figure 2 shows the wiring of a Xelos A42 with a TV set placed
in the rack as an example.
Place the desired additional equipment in the rack.
Take the socket strip provided.
Pull the backing foil off the bottom of the socket strip.
Stick the socket strip in the position in the rack marked by
arrow D in fi g. 4. Lay the power cable of the socket strip as
shown.
Your screen requires at least two connecting cables (1 power
cable and one antenna / Sat cable).
If you need Scart cables for your additional equipment, connect
the plugs to the sockets on the screen fi rst.
If connecting cables are visible we recommend you to lay the
cables in a fabric tube in this area. See also the information
overleaf.
Fix the cables in the cable tie on the screen.
Then feed the cables down. Do not pull the cables down too
tightly. Otherwise they will obstruct rotation of the screen on
the Xelos A 42 Rack.
You can fi x the cables additionally in the cable recess in the rack
with the cable tie provided, fi g. 4, arrow G.
Handling of the three self-adhesive cable ties, fi g. 2, arrows C,
arrow G.
Remove the backing strip (underside of cable tie).
Stick the cable tie to the rack as suggested.
Fasten the cables in the cable tie as shown.
Feed the plugs of the cables through the openings (arrow E and
F) in the rack to the set auxiliary equipment.
Note
Please see the operating manual of your set for a detailed description of
the assignment of sockets and cables.
fi g. 4
ANT-SAT
89352.001
13/18 V /350 mA
ANT-TV
5 V /80 mA
G
C
F
E
AUD IO IN AUD IO OUT
C L R L R SERVICE
HDT V IN
SD/HD -CO MPONENT IN AUD IO DIGI TA L
AV 1 AV 2
( RGB / YUV ) C /P b b C /P r r Y IN OUT HDMI DVI ( ) VGA/XGA
A A
C
9