Cequent Performance Products 51147 Instrucciones De Instalación

Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: 51147F
Wrenches: 19mm
Drill Bits: None
1
Qty. (6) Hex Bolt M12 x 1.25 x 35mm
2
Qty. (6) Lock Washer
1. Raise hitch into position and install fasteners as shown above.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z
2009 Cequent Performance Products
Installation Instructions
Existing weldnuts
Tighten all M12 CL8.8 fasteners with torque wrench to 68 Lb.-Ft. (92 N*M)
Nissan Frontier
Suzuki Equator
Bumper
Do Not Exceed Lower of Towing Vehicle
Hitch type
Weight Distributing
Weight Carrying
Ball Mount
Wiring Access Location: PU3
Frame rail
Vertical plate present
On some models
Note: Fasteners typical both sides
3
Qty. (6) Flat Washer
Sheet 1 of 3
Manufacturer's Rating or
Max Gross
Trailer WT (LB)
8,000 (3 632 Kg)
5,000 (2 270 Kg)
3
2
1
51147N 8-11-09
Form: F205 Rev A 5-6-05
Part Numbers:
51147
Max Tongue
WT (LB)
800 (363 Kg)
500 (227 Kg)
Rev. A