Cequent Performance Products 76074 Instrucciones De Instalación página 4

1. Lower muffler – Lower muffler by removing the (2) rearmost rubber
hangers. Note: A spray a lubricant on rubber hangers makes them slide
off metal pins more easily. NOTE: Be careful that exhaust is supported
before removing rubber hangers.
3. Raise hitch into position – raise the hitch over the tailpipe(s) and
align holes in hitch with existing weldnuts in frame rail.
©2016 Cequent™ Performance Products, Inc. - Printed in Mexico
2. Remove underbody appearance panels (if present) – remove (2)
plastic underbody appearance panels, (1) each side, located under the
rear bumper and behind the rear wheels. Using a standard screwdriver,
remove the plastic push rivets from each panel and pull down to remove
the panels from plastic push nuts. Set aside for reinstallation later.
4. Install fasteners - Install (7) M10 bolts and conical toothed washers
as shown in figure 1.
Sheet 4 of 15 76074NP 5-31-16 Rev. A