Kettler STARTRIKE Manual De Instrucciones página 6

GB IRL
loose connections (screws, plug-in connections).
■ Damaged or worn parts must be replaced straight away and the vehicle must be with-
drawn from use until repaired. If required please only use original KETTLER spare parts.
■ Improper repairs and structural alterations (disassembly of original parts, fitting of not
permitted parts, etc.) may cause danger for the user or affect the life span of the product.
■ Please bear in mind that there is always a danger of children injuring themselves (falling
off, tipping over etc.) whilst using swings, climbing frames, tricycles or similar equipment.
■ Do not connect this toy to any other product; because this child's wheeled toy has not been
designed for higher speeds.
■ Please bear in mind that children are very often not able to judge their own capabilities
and certain (dangerous) situations. Also consider that a natural urge to play plus their tem-
perament may lead children into unforeseen situations for which the manufacturer cannot
be held responsible.
■ This wheeled toy does not have lights. It is dangerous to use it in the dark.
■ When mounting the product please take the recommended torque information into
account (M = xx Nm).
Handling
■ Before use always check that all screws and plug-in connections and respective safety
devices fit correctly.
■ Instruct children in the correct use of the product, and draw their attention to possible dangers.
■ Please note that pedals on any wheeled toy without freewheeling appliance will turn even
if the product is being pushed or is coasting.
■ This wheeled toy does not have a so-called parking brake. Therefore secure the vehicle
against rolling away. Do not leave children, who are not old enough to use the wheeled
toy, unattended on a product.
■ If this product can be adjusted please adapt it to your child's height.
■ Do not transport anything on this product.
■ Never use corrosive or abrasive substances to clean the toy. Never use substances which
may cause pollution of the environment.
■ Lubricate the bearing sleeves of the wheels and the handlebars with a few drops of oil
every two or three months.
■ For models with push bars: Always ensure that the push bar fits correctly in the adaptor,
and locks. Do not hang any weights on the bar! The vehicle may tip over, and your child
may be hurt. The push bar is intended for adult use only, do not pass responsibility for
children on to other children. For free play time take the push bar off for safety reasons.
■ For models with pneumatic tyres: When leaving wheeled toys with pneumatic tyres on floors
containing solvents or which have been glued with such solvents (e.g. PVC) they may possi-
bly stain it due to a chemical reaction with the natural product caoutchouc. If in doubt place
something underneath the wheels. Ensure that air pressure in the tyres is correct (2,5 bar/36
PSI); if air pressure is too low this increases wear, and makes riding the toy more difficult!
Assembly of the toy vehicle
CAUTION!
Ensure that your working area is free of possible sources of danger, for example
!
don't leave any tools lying around. Always dispose packaging material in such a way that it
may not cause any danger. There is always a risk of suffocation if children play with plastic
6