Notes
• Do not use USB devices so large or heavy that
they may fall down due to vibration, or cause a
loose connection.
• Do not detach the front panel during playback
of the USB device, otherwise USB data may be
damaged.
Changing display items
Displayed items may differ depending on
the USB device, recording format and
settings.
Press .
Notes
• The maximum number of displayable data is as
follows.
– folders (albums): 128
– files (tracks) per folder: 500
• It may take time for playback to begin,
depending on the amount of recorded data.
• DRM (Digital Rights Management) files may
not be played.
• During playback or fast-forward/reverse of a
VBR (Variable Bit Rate) MP3/WMA/AAC file,
elapsed playing time may not display
accurately.
• Playback of the following MP3/WMA/AAC
files is not supported.
– lossless compression
– copyright-protected
12
iPod
In these Operating Instructions, "iPod" is
used as a general reference for the iPod
functions on the iPod and iPhone, unless
otherwise specified by the text or
illustrations.
For details on the compatibility of your
iPod, see "About iPod" (page 22) or visit the
support site on the back cover.
Playing back iPod
Before connecting the iPod, turn down the
volume of the unit.
1
Open the USB cover, then connect the
iPod to the USB connector with the
USB connection cable for iPod (not
supplied)*.
* Using the RC-100IP USB connection cable
for iPod is recommended.
The tracks on the iPod start playing
automatically from the point last played.
If an iPod is already connected, to start
playback press
repeatedly until "USB" appears. ("IPD"
appears in the display when iPod is
recognized.)
Press and hold for 1
second to stop playback.
To remove the iPod, stop the iPod playback,
then remove the iPod.