Bevel Gear - Husqvarna 426LST Manual De Instrucciones

An air filter that has been in use for a long time cannot be
cleaned completely. The filter must therefore be replaced
with a new one at regular intervals. A damaged air filter
must always be replaced.

Bevel gear

There is a grease nipple on the gearbox. Use a grease
gun to top up with grease. This should be carried out after
approximately every 25 working hours. Use Husqvarna
special grease.
Remove the drive disc before installing new grease to
arrange for old grease to exit.
CAUTION! When removing and installing the drive disc,
use care not to allow any dirt and dust entering into the
gear case.
CAUTION! Use only HUSQVARNA replacement parts.
Use of other brands of replacement parts can cause
damage to your unit or injury to the operator or others.
Your warranty does not cover damage or liability caused
by the use of accessories and/or attachments not
specifically recommended by HUSQVARNA.
1155667-49 Rev. 2 2015-02-05
MAINTENANCE
–
English 19