Troubleshooting - Skil 9296 Instrucciones De Funcionamiento Y Seguridad

SM 2610025798 10-12_SM 2610025798 10-12.qxp 10/12/12 9:32 AM Page 15
Read instruction manual first! Remove plug from the power source before
WARNING
making adjustments or assembling accessories.
TROUBLE: TOOL WILL NOT START
PROBLEM
1. Power cord is not plugged in.
2. Power source fuse or circuit breaker tripped.
3. Cord damaged.
4. Burned out switch.
REMEDy
1. Plug tool into power source.
2. Replace fuse or reset tripped circuit breaker. (If the product repeatedly causes
the circuit or fuse to trip/blow, discontinue use immediately and have it serviced by
an Authorized Skil Service Center or Service Station.)
3. Inspect cord for damage. If damaged, have cord replaced by an Authorized Skil
Service Center or Service Station.
4. Have switch replaced by an Authorized Skil Service Center or Service Station.
TROUBLE: TOOL DOES NOT COME UP TO SPEED
PROBLEM
1. Extension cord has insufficient gauge or is too long.
2. If equipped with variable speed, tool may not set at maximum RPM.
3. Low house voltage.
REMEDy
1. Replace with adequate extension cord (Page 14).
2. If equipped with variable speed, check speed setting.
3. Contact your electric company.
Trouble Shooting
-15-