Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Read and follow all instructions and Safety Precautions before using this
The FLG5 gravity spray gun is fitted with a 1.4 or 1.8mm nozzle for topcoat applications.
Alternative 2.0mm nozzle and needles are available for primer use. The FLG5 gravity-feed
spray gun is approved to ATEX regulations 94/9/EC, protection level;
Important: These spray guns are suitable for use with solvent-based coating materials. The
design uses EPA compliant atomising (Devilbiss Trans-Tech®) technology to reduce overspray
and improve coating efficiency. Nozzles and needles are manufactured in stainless steel. These
guns are not designed for use with highly corrosive and/or abrasive materials and if used with
such materials it must be expected that the need for cleaning and/or replacement of parts will
be increased. If there is any doubt regarding the suitability of a specific material contact your
local Distributor or Finishing Brands UK Limited direct.
Example:
Air supply connection -
Maximum static air inlet pressure -
Nominal gun inlet pressure with gun triggered -
Maximum service temperature -
Gun weight -
Air flow -
Gun body
Nozzle
Needle
Cup
Finishing Brands UK Limited reserves the right to modify equipment specification without prior notice.
Important
equipment
Description
II 2 G X. Suitable for use in Zones 1 and 2
Model Part No.
FLG-G5-14
Specification
Materials of Construction
Universal ¼" BSP and NPS
P
= 12 bar (175 psi)
1
2.4 bar (35 psi)
40°C
640 g
277 l/min (9.8 cfm)
-
Aluminium
-
Stainless steel
-
Stainless steel
-
Acetal and stainless steel
2
Nozzle Size
1.4/1.8
© 2012 Finishing Brands UK Ltd.
Publicidad
Tabla de contenido
