Step 14
Carefully turn your unit over onto its front edges. Place the
å
BACKS (I) over the ENDS and UPRIGHTS.
Make equal margins along the sides of the BACKS (I).
å
Push on opposite corners of your unit if needed to make
it "square".
Fasten the BACKS (I) to your unit using the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line up
å
over the BOTTOMS (F and G).
NOTE: Perforations have been provided for access
å
through the BACK. Carefully cut out the rectangle in the
BACK for proper ventilation of your CPU.
These holes must line up
over the RIGHT BOTTOM (F).
www.sauder.com/services
I
F
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
These holes must line up
over the LEFT BOTTOM (G).
I
G
419395
1N
NAIL
(30 used in this step)
Page 19