Dryer Plenum Air Hose Assembly - Bradley Advocate AV90 Manual Del Usuario

AV90

Dryer Plenum Air Hose Assembly

5
The dryer hood is factory-installed. For
clarity, the basin, soap assembly and
faucet assembly are not shown.
Attach air hose from left upper
B
dryer plenum thru dryer hood
base opening and down to
lower dryer plenum.
Orient worm gears
A
to sides so that dryer
hood can be closed.
14
Dryer Hood
Base Pocket
Dryer Hood
Base Opening
1/21/2014
Dryer Hood
Cover Tab
Attach air hose from right upper dryer
C
plenum thru dryer hood base opening
and down to dryer motor assembly inlet.
To Reinstall the Dryer Hood Cover
Dryer Hood
Bradley • 215-1773 Rev. D; ECN 13-08-028
AV30 is shown. AV90 is similar.
Remove Dryer
Hood Cover
Upper Dryer Plenum
Air Hose (Attached
by Bradley)
Remove (2) #10 x 1½"
A
screws (use
Driver) and lift cover up
and back to remove.
Position the dryer hood
A
cover tabs into the dryer
hood base pockets.
Secure the cover to the
B base with the two #10 x
" screws. Use ¹⁄₈" hex
³⁄₈
driver to remove screws.
Installation
Hex
¹⁄₈"