Kobra AF+1 Instrucciones De Manejo página 7

WARNINGS - IMPORTANT
BEFORE USING THE MACHINE, FIRST READ THE INSTRUCTIONS
FOR USE AND THE FOLLOWING WARNINGS.
Before plugging in the shredder make sure that the voltage
and the mains supply correspond to what is written on the
plate on the machine.
UNPLUG THE POWER CABLE IN THE FOLLOWING CASES:
-BEFORE CHANGING OR EMPTYING THE SHREDDED PAPER
COLLECTION BAG
-BEFORE LIFTING THE MACHINE FROM ITS BASE
-BEFORE ANY MAINTENANCE OR REPAIRS OR TOUCHING
THE INTERNAL PARTS OF THE MACHINE
NOMINAL VOLTAGE: CONTINUOUS OPERATION
NOMINAL VOLTAGE +10%: MAX. OPERATION 50 MIN.
FEATURES
Congratulations on purchasing an auto-feeder KOBRA
AF range document shredder.
The KOBRA AF.2 COMPACTOR model is also equipped
with an automatic paper compacting system which
reduces the volume of shredded paper, increasing by
4 times the collection bag capacity.
INSTALLATION (FIG.1)
Make sure power socket is easily accessible and
situated near to the machine. Take the machine out of
its packaging, position the machine head (A) on the
base (B). Open the door (C), slide the bag holder frame
(D) from its tracks (E).
Fit the plastic bag (F) which comes with the machine
onto the bag holder frame (D) and slide it back onto its
tracks (E). Push the frame right in and close the door
again.
OPERATING THE MACHINE (FIG.2)
Once the shredder has been plugged in, turn the switch
(H) to the "I" position. The light (G) will come on for a
few seconds and the machine will start a shred cycle.
If no documents to be shredded have been inserted
into the machine it will automatically go on stand-by.
Now it is possible to shred documents at any time.
With the switch (H) in the "O" position, all functions are
switched off.
By putting the button (H) in the "R" position at any
time and with any kind of paper you can interrupt
shredding and extract the document by putting the
machine in reverse.
PAY ATTENTION TO THE FOLLOWING WARNINGS
PRINTED ON THE TOP OF THE MACHINE:
REFER TO THE OPERATING INSTRUCTIONS
WARNING!
SAFETY PRECAUTIONS
KEEP NECK TIES OR OTHER DANGLING OBJECTS
AWAY FROM THE THROAT
DO NOT PUT YOUR HANDS IN THE THROAT
AND THE CUTTING KNIVES
DO NOT ALLOW CHILDREN TO OPERATE THE
DEVICE
KEEP LONG HAIR AWAY FROM THE THROAT
DO NOT USE AEROSOL PRODUCTS OR
LUBRICANTS
MANUAL SHREDDING OF SINGLE SHEETS
Insert sheets in the throat (L) and the light indicator
(G) comes on and the machine starts shredding
automatically as two photocells inside the throat
detect the presence of paper and automatically stop
the shredding knives a few seconds after shredding
has finished.
If you insert a greater quantity of paper than the
shredding capacity, the machine will automatically go
into reverse and eject the excess paper.
Take the excess paper out of the throat in order to free
the photocells then insert a smaller amount of paper
and the machine will automatically restart and finish
shredding with a shred cycle.
It is advisable to limit jams caused by introducing
too much paper and to operate the machine below
maximum capacity in order to prolong the life of
mechanical parts and the life of the machine itself.
AUTOMATIC PAPER SHREDDING (FIG.3)
Open the top cover of the paper feeder tray as shown
in figure 3.. Insert a maximum of 300 sheets of A4 paper
in the feeder tray and in any case ensure they are not
higher than the maximum load mark (A). Close the top
cover, the machine automatically starts shredding and
automatically stops when shredding is finished.
IMPORTANT:
The automatic function can be used for bound blocks
up to a maximum of 25 sheets. Provided the type of
staple used is no longer than 6 mm and the block is
inserted with the points facing downwards
7
KOBRA AF+1 • AF.1 • AF.2