Installation; Installing/Replacing The Lamps - EuroLite CLS-80 Manual Del Usuario

Operate the device only after having become familiar with its functions. Do not permit operation by persons
not qualified for operating the device. Most damages are the result of unprofessional operation!
Please use the original packaging if the device is to be transported.
Please consider that unauthorized modifications on the device are forbidden due to safety reasons!
Never remove the serial barcode from the device as this would make the guarantee void.
If this device will be operated in any way different to the one described in this manual, the product may suffer
damages and the guarantee becomes void. Furthermore, any other operation may lead to dangers like
short-circuit, burns, electric shock, lamp explosion, crash etc.

INSTALLATION

Installing/Replacing the lamps

Before replacing the lamp, unplug mains lead and let the lamp cool down (approx. 5 minutes).
During the installation do not touch the glass-bulbs bare-handed! Please follow the lamp manufacturer's
notes!
Do not install lamps with a higher wattage! Lamps with a higher wattage generate temperatures the device
was not designed for. Damages caused by non-observance are not subject to warranty.
If one lamp burns out, the second lamp of the pair of lamps will not work either, as the electric circuit is
interrupted (connected in series).
For the installation, you need eight ENH 120 V/250 W GY-5,3 lamps.
During the operation, the lamp reaches temperatures of up to 200° C.
Caution! The lamps are extremely shock-sensitive!
Please follow the lamp manufacturer's notes!
DANGER TO LIFE!
Only install the lamps with the device switched off!
Unplug from mains before!
CAUTION!
The lamp has to be replaced when it is damaged
or deformed due to the heat!
13/31 41907050X87NXS_V_1_0.DOC