ION Wave Rider Max Guia De Inicio Rapido página 7

Stereo-Link™: Linking Two Speakers Together Wirelessly
1. Power on both Wave Rider Max speakers.
Note: In order to use Stereo-Link Mode, you cannot have a Bluetooth device connected.
If one speaker is connected to a Bluetooth device, break the connection by pressing and
holding the Bluetooth button.
2. With no Bluetooth device connected (blue LEDs on both speakers will blink), on one
Wave Rider Max press and hold – and + until you hear a short 3-tone melody; repeat this
for the second Wave Rider Max. The melody will indicate the Wave Rider Maxs are
searching for each other to link as their blue LEDs begin to blink fast.
3. Wait about 10-30 seconds for the Wave Rider Maxs to find each other. Once "linked,"
one Wave Rider Max will say "Paired" (if the voice prompts are enabled). Now that the
two speakers are "linked," one speaker's blue LED will be solid, while the other speaker's
blue LED will blink slowly to indicate it's ready to pair the stereo-linked speakers to your
Bluetooth device (e.g., your phone).
4. When the Wave Rider Max speakers are wirelessly linked to play in stereo, navigate to
your Bluetooth device's setup screen, find Wave Rider Max and connect.
5. Once your smartphone is paired, you will hear "Paired" (if the voice prompts are enabled)
and audio can now play out of both speakers in stereo.
•
In Stereo-Link Mode: UI Controls on both speakers will be active.
•
To exit Stereo-Link Mode, press and hold – and + until the speaker goes back into
pairing mode, saying "Ready to Pair".
•
In Stereo-Link Mode, press Power to turn off both speakers.
Note: If a Wave Rider Max is in Stereo-Link Mode when you power it off, it will be in Stereo-
Link the next time you power it on. That means if two Wave Rider Maxs are linked when you
power them off, they will automatically link when you power them on as long as they are in
close range of each other and powered on within 15 seconds of each other.
Note: If a Wave Rider Max is in Stereo-Link Mode when you power it off, when you power it
back on, it will revert back to single mode, and be ready to pair to a Bluetooth device if it does
not find another Wave Rider Max to link to within 15 seconds. To re-enter Stereo-Link Mode,
follow Steps 1–5 above.
7