Bosch GSB18V-535C Instrucciones De Funcionamiento Y Seguridad página 16

2610067378 05-21 GSB18V-535C.qxp_GSB18V-535C 5/19/21 1:37 PM Page 16
KickBack Control
(Rapid Shut-off)
To ensure better control of the tool
during operation, this tool is design to
shut-off while in use if a sudden or
unexpected bind up situation occurs. Bind up
occurs when the bit gets jammed during
operation, which forces the bit to stop spinning
abruptly. If this occurs, the tool will shut down
and the KickBack Control will be indicated by
flashing LED lights on the tool.
The sensitivity level of this feature is adjustable.
Using Bosch Toolbox app on a mobile device,
operator may select one of three settings
between "Earlier" and "Later" markers on the
app. The settings only control the KickBack
Control activation delay, and do not change the
capacity of this feature.
When the switch trigger is pressed, operator is
notified about the KickBack Control settings, by
the work light and function red light identified in
Fig. 1 on page 9.
16
Operating Instructions
The setting indications are as follows:
W
R W R
R R R R W W W W
The label next to the work light displays the Kick
Back setting indicator light pattern.
This feature can only be activated when the tool
is running at maximum speed.
NOTE: The default KickBack Control setting for
the tool is "Later". KickBack Control setting for
the tool without GCY42 module installed is
always set to default.
SAVE THESE INSTRUCTIONS
Continuous white light (W) = Later
(delayed Kick Back activation).
Slow alternating red (R) and white (W)
W
light = Mid-Level (less delayed activation).
Fast alternating red (R) / white (W) light =
Earlier (minimum delay to activation).
RED LIGHT WHITE LIGHT