Taurus ALPATEC AC 280 Manual Del Usario página 20

English
space of 50cm front other walls, ceiling.
- The plug must be easily accessible so
it can be disconnected in an emergency.
- To achieve the highest efficiency from
the appliance it should be situated
in a place where the atmospheric
temperature is between 12 and 32ºC.
- Ensure that the extraction pipe remains
in a horizontal position. (Fig 2)
- Do not add new sections to the
extraction tube provided, as it could
cause the appliance to malfunction.
- The appliance should be used with its
base feet fitted.
- The appliance should be used with its
wheels attached.
Assembly of the exhaust hose
- Lengthen one head
of the hose, and spin
the exhaust hose into
exhaust connector
(counter-clockwise).
Instructions for use
Use:
- Unroll the cable completely before plugging it in.
- Connect the appliance to the mains.
- Press the ON/OFF button, the unit will enter in
cooling mode with low fan speed.
- Press the mode button to select cooling
dehumidifying, fan and heating mode.
Fan Speed:
- Under the cooling and the fan mode, the speed
goes as follow:
- Lower Fan-> Mid Fan-> High Fan.
- Under the dehumidifying mode, fan is working
in low speed.
Timer function:
- The appliance´s operating time can be controlled
from 1~24h.
- Press that button. If you press the button once,
the appliance will working 1 hour, if you press
twice, 2 hours etc up to 24 hours.
- Auto-shut off timer is only available when the
unit is on.
- Under the cooling and heating mode, the setting
temperature ranges from 16º~31ºC.
Swing:
- Press this button to control the movement of the
louver.
Cooling mode:
- Press mode to select cooling mode, cooling
mode indicator turns on.
- Press Up or Down to adjust temperature from
16ºC to 31ºC.
- Press speed to select high or low fan speed.
Fan mode:
- Press mode to select fan mode fan indicator
turns on.
- Press speed to select high speed or low speed.
- Temperature and sleeping function cannot be
setup.
Dehumidifying mode:
- Press "MODE" to select dehumidifying mode,
dehumidifying mode indicator turns on.
- Under dehumidifying mode, sleeping function
cannot be setup, and fan speed is low.
Sleeping mode:
- Press key "SLEEP" enters into sleeping mode,
default value of fan speed is low.
- When sleeping mode turns on , under cooling
mode, the first one hour later, setting temperature
will go up 1ºC, the second one hour later, setting
temperature will go up another 1ºC, and then keep
the same .
- Sleeping mode is invalid under dehumidifying
and fan mode. Under water full, machine standby
and mode conversion, sleeping mode will be
cancelled.
Compressor protection:
- Three minutes later after power on / restart,
compressor starts to run.