Troubleshooting; Safety Notices; Fault Indications And Rectification Of Faults - CASO DESIGN WineComfort 380 Smart Instrucciones De Funcionamiento Originales

16 Troubleshooting

This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:

16.1 Safety notices

Attention
► Only qualified electricians, who have been trained by the manufacturer, may carry out any
repairs on electrical equipment.
► Improperly performed repairs can cause considerable dangers for the user and damages
to the device.

16.2 Fault indications and rectification of faults

The following table assists in localizing and rectifying minor faults.
Fault
Wine refrigerator do not
operate.
Your device is not cold
enough or it does not reach
the adjusted temperature:
The light does not work.
Vibrations.
The wine refrigerator seems
to make to much noise
The door will not close
properly.
LED could not display.
LED display error - Lo
Buttons are not functional.
Not plugged in using different voltage. The circuit breaker
tripped or a blown fuse.
Check the temperature control setting.
External environment may require a higher setting.
The door is open too often. The door is not closed
completely.
The door seal does not seal properly.
The wine refrigerator does not have the correct
clearance.
Defrost the device.
Check the service center.
Check to assure that the wine refrigerator is level.
The wine refrigerator is not level.
Check the fan.
The wine refrigerator is not level.
The door is reversed and not properly installed.
The seal is weak. The shelves are out of position.
Main control board does not work.
PCB Problem. There is some problem with the plug.
Display problem.
PCB problem. Check the service center.
Temperature controller panel is damaged.
Possible Cause
38