Perel EDP1 Manual Del Usuario página 8

6. Operation
Refer to the illustrations on page 2 of this manual.
1. Make sure both the receiver and transmitter are powered.
2. The receiver [2] will ring when the button on the transmitter [1]
is pressed.
3. Select the melody with the melody selector [4] and adjust the
volume with volume control button [3].
7. Pairing
1. On the receiver, hold the button pressed for 5 seconds until you
hear a "ding-dong" sound.
2. Now, press the transmitter button. The transmitter emits a
"ding" sound to confirm successful pairing. The receiver emits a
"ding-dong" sound when it exits the pairing mode.
8. Technical Specifications
wireless ................................................................ yes
operating range .............................. 150 m in open area
self-learning .......................................................... yes
bell push.......................................... with LED indicator
number of sounds ................................................... 32
IP rating (transmitter) .......................................... IP44
power supply
transmitter .................................. 1 x CR2032 (incl.)
Use this device with original accessories only. Velleman nv
cannot be held responsible in the event of damage or injury
resulting from (incorrect) use of this device. For more info
concerning this product and the latest version of this manual,
please visit our website www.perel.eu. The information in this
manual is subject to change without prior notice.
RED Declaration of Conformity
Hereby, Velleman NV declares that the radio equipment type [EDP1]
+ [EDPTW] is in compliance with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the
following internet address: www.velleman.eu.
V. 04 – 23/04/2019
EDP1/EDPTW
7 ©Velleman nv