Chamfering Edges - DeWalt D26500 Manual De Instrucciones

EN GLI SH
The tool is supplied with an adapter for connecting
a dustbag or a vacuum extractor. The dustbag is
standard for K-models and available as an option for
all other models.
1. Fit the shavings ejector (r) into the outlet (c) as
shown.
2. Attach the dustbag (u) to the shavings ejector.
3. Alternatively, connect the tool to a vacuum
extractor using the adaptor (v).
ASSEMBLING THE DUSTBAG (FIG. 9)
1. Assemble the dustbag by aligning the open
ended slots (z) with the notches (y) and fitting
the (w) deflector onto the bag (x).
2. Turn the assembly clockwise to lock it in
position.
3. Release the loops (zz) to unfold the bag.
4. Fit the dustbag as described above.
Prior to Operation
• Adjust the depth of cut.
• If necessary, fit and adjust the parallel fence.
• Attach the shavings ejector.
• Use sharp cutting blades only.
OPERATION
Instructions for Use
WARNING: Always observe the safety
instructions and applicable regulations.
WARNING: To reduce the risk
of serious personal injury, turn
tool off and disconnect tool from
power source before making any
adjustments or removing/installing
attachments or accessories.
Proper Hand Position (fi g. 10)
WARNING: To reduce the risk of
serious personal injury, ALWAYS use
proper hand position as shown.
WARNING: To reduce the risk of
serious personal injury, ALWAYS hold
securely in anticipation of a sudden
reaction.
Proper hand position requires one hand on the front
handle (d), with the other hand on the main handle
(t).
28
Switching On and Off (fi g. 1)
For safety reasons the on/off switch (a) of your tool is
equipped with a lock-off button (b).
1. Press the lock-off button to unlock the tool.
2. To run the tool, press the on/off switch (a). As
soon as the on/off switch is released the lock-
off switch is automatically activated to prevent
unintended starting of the machine.
WARNING: Do not switch the tool
on or off when the cutters touch the
workpiece or other materials.
Planing (fi g. 1)
1. Switch the tool on.
2. Slowly move the tool over the workpiece.
WARNING:
• The feed speed should not be too
high, especially when using the
maximum depth of cut and planing
width.
• Remember that several shallow cuts
are better than one deep cut.
• Always switch off the tool when work
is finished and before unplugging.
The tool is equipped with a parking shoe (f). After
switching off the tool can be put down without
waiting for the cutters to come to a standstill.
Rebating
1. Fit and adjust the parallel fence.
2. Fit and adjust the rebating depth stop.
3. Proceed as for planing.

Chamfering Edges

The V-grooves in the nose piece of the shoe enable
you to chamfer edges.
Emptying the Dustbag (fi g. 7–9)
The amount of shavings collected in the dustbag
can be determined from the transparent deflector.
1. Remove the dustbag (u).
2. Remove the deflector (w) from the bag (x) by
turning it counter-clockwise.
3. Empty the contents of the bag into a waste
container.
4. Re-assemble the dustbag by aligning the open
ended slots (z) with the notches (y) and fitting
the deflector onto the bag.