Husqvarna FS7000 D Manual Del Usuario página 24

Blade depth stop
The product has the function blade depth stop that lets
the operator set the maximum cutting depth. The
maximum cutting depth is different for different blade
dimensions:
Dimension, mm/in.
350/14
500/20
650/26
750/30
900/36
1000/42
1000/48
1500/60
To set the cutting depth
1. Push the switch for cutting depth adjustment down to
lower the cutting blade until it touches the surface.
This is the start position for the cutting depth.
CAUTION: Do not lower the cutting
blade too quickly. If the cutting blade hits
the surface with force, it can cause
damage to the cutting blade. Decrease
the speed with the knob for adjustment
of the blade lowering speed.
24
Max. cutting depth, mm/in.
118/4.75
193/7.75
262/10.5
312/12.5
374/15
411/17.5
498/20
623/25
2. Push the reset button for the blade depth stop on the
control panel. The cutting depth value is set to 0
in./mm on the display.
12
14
5.0
WORKING HOURS
18 110
V
CURRENT: STOP:
0 mm 0 mm
3. Push the button adjacent to the symbol for blade
depth stop. The symbol on the display changes color
to show that the function is engaged.
180
150 210
110 250
˚F
4. Turn the knob for adjustment of the blade depth stop
until the correct cutting depth shows on the display.
During operation, the cutting blade is not lowered
more than the set cutting depth.
10 14
5.0
WORKING HOURS
8 18
V
CURRENT:
0 cm
RPM
CAUTION: Always do a check that the
cutting depth is correct. The blade depth
stop helps you to get the correct cutting
depth but only gives an indication of the
depth value.
5. If it is necessary to increase the cutting depth, do 1
of these procedures:
a) Turn the knob for adjustment of the blade depth
stop to set a new cutting depth.
b) Push the button adjacent to the symbol for blade
depth stop to disengage the function. The symbol
on the display changes color to show that the
function is disengaged.
To start the product
1. Connect the water inlet to a water supply.
180
150 210
250
˚F
150 210
110 250
˚F
STOP:
4 cm
DEPTH
1223 - 002 - 09.07.2019
RESET
RESET