Husqvarna R 214T Manual De Usuario página 27

Problem
The engine does not start when
the start motor turns the engine
over
The engine does not run smooth-
ly
The engine apparently has no
power
The transmission does not have
sufficient power
The battery does not charge
There is vibration in the product
The cutting result is unsatisfacto-
ry
850 - 003 - 14.11.2018
Cause
There is no fuel in the fuel tank. See
The spark plug is defective.
The ignition cable is defective.
There is dirt in the carburettor or fuel line.
The spark plug is defective.
The carburettor is incorrectly set.
The air filter is clogged. See
The fuel tank vent is blocked.
There is dirt in the carburetor or fuel line.
The air filter is clogged. See
The spark plug is defective.
There is dirt in the carburetor or fuel line.
The throttle cable is incorrectly adjusted.
The transmission cold air intake or the cooling fins are blocked.
The fan on the transmission is damaged.
There is no oil in the transmission or the oil level is too low. See
of the transmission oil level on page 25 .
The battery is defective. See
The connection at the cable connectors on the battery terminals is bad. See
tery safety on page 9 .
The blades are loose. See
One or more of the blades are unbalanced. See
23 .
The engine is loose.
The blades are blunt. See
The grass is long or wet. See
The cutting deck is skew.
There is grass blockage in the cutting deck. See
16 .
The tire pressure is different on the right and left sides. See
page 21 .
The product is operated at a too high speed. See
page 14 .
The engine speed is too low. See
The drive belt slips.
To fill fuel on page 11 .
To clean and change the air filter on page 18 .
To clean and change the air filter on page 18 .
Battery safety on page 9 .
To examine the blades on page 23 .
To examine the blades on page
To examine the blades on page 23 .
To get a good cutting result on page 14 .
To clean the product on page
To get a good cutting result on page 14 .
To do a check
Tire pressure on
To get a good cutting result on
Bat-
27